The AT25160AN-10SQ-2.7 provides 16384 (2048 x 8) bits of serial electrically-erasable programmable read-only memory (EEPROM) organized as 2048 words of 8 bits each. The device is optimized for use in many automotive applications where low-power and low-voltage operation are essential. The AT25160AN-10SQ-2.7 is enabled through the Chip Select pin (CS) and accessed via a three-wire interface consisting of Serial Data Input (SI), Serial Data Output (SO), and Serial Clock (SCK). All programming cycles are completely selftimed, and no separate erase cycle is required before write. Block write protection is enabled by programming the status register with one of four blocks of write protection. Separate program enable and program disable instructions are provided for additional data protection. Hardware data protection is provided via the WP pin to protect against inadvertent write attempts to the status register. The HOLD pin may be used to suspend any serial communication without resetting the serial sequence.
Serial Peripheral Interface (SPI) Compatible
Supports SPI Modes 0 (0,0) and 3 (1,1)
Medium-voltage and Standard-voltage Operation (VCC = 2.7V to 5.5V)
Extended Temperature Range -40°C to 125°C
5.0 MHz Clock Rate
32-byte Page Mode
Block Write Protection - Protect 1/4, 1/2, or Entire Array
Write Protect (WP) Pin and Write Disable Instructions for Both Hardware and Software Data Protection
Self-timed Write Cycle (2 ms [5V] typical)
- Endurance: One Million Write Cycles
- Data Retention: 100 Years
SOIC 8 package. Manufactured by Atmel.
A20572SA - Sold in a package of 5.